Shenzhen Gold Exchange Fire Tank

Financial-exchange buildings put a high value on fire protection continuity and on the ability to verify the installation before handover. The Shenzhen Gold Exchange project is a reference for a fire water tank in a financial building, where the recorded scope included roof load review, non-standard dimensions and a pressure test before acceptance.

Project profile

Item Public project record
Project Shenzhen Gold Exchange fire water tank
Location Shenzhen, Guangdong, China
Application Fire water reserve for a financial building
Scope recorded Roof load review, non-standard tank dimensions, pressure test and acceptance
Capacity / date Not disclosed in the public record; confirm with the project team before reuse

This is a project reference profile. The tank capacity, final dimensions and completion date are not stated because they are not confirmed in the public record. The page focuses on the application and the engineering checks that a similar commercial project should plan for.

The challenge

A financial building typically has a dense core, limited plant space and a fire strategy that cannot be interrupted for construction access. The fire tank may be located on a roof, a podium or a basement plant room. Each location brings a different constraint: roof load and wind uplift, podium transfer structure, or basement access and lifting.

A non-standard tank shape is common when the plant room is already fixed by the building services layout. The tank has to fit around pumps, risers, cable routes and maintenance access. If the geometry is developed without a coordinated drawing, the tank may fit the room but not the access route, or the connections may end up behind a pipe bank.

The solution

The project used a stainless steel fire water tank with a project-specific geometry. The recorded scope includes a roof load review, non-standard dimensions and a pressure test. The load review links the filled tank weight to the supporting structure; the pressure test confirms the assembled tank and connections before acceptance.

The tank was arranged so that the fire reserve connections, vent, drain and inspection access could be reached from the plant area. In a commercial building, the maintenance access is part of the fire protection reliability: a tank that cannot be inspected cannot be maintained with confidence.

Why the material matters

For a fire reserve, the tank may be uncoated stainless or a coated steel system. Stainless is selected where the project wants a clean contact surface, a replaceable panel system and local repair capability. The grade should be confirmed against the water chemistry; SS304 is common for neutral water, while SS316 is used where chloride or a project specification requires it.

The fire code and the AHJ may impose additional requirements on the tank, outlet, make-up and access. These should be stated in the enquiry. A supplier can design to the stated basis, but the AHJ approval and the fire-system acceptance remain project responsibilities unless separately contracted.

What the project demonstrates

  • A commercial fire tank should be reviewed against the building structure and the plant-room layout together.
  • Non-standard dimensions need a coordinated drawing and a connection schedule.
  • Pressure testing is a hold point before the fire system is accepted.
  • Inspection access is part of fire-protection reliability, not a cosmetic detail.
  • Material grade should follow water chemistry and the project specification.

Lessons for a similar project

Start the tank review early enough to influence the plant-room layout. Confirm the fire design basis, the available footprint, the roof or basement load limit and the largest deliverable component. If the tank must pass through a basement door or a service lift, confirm the panel size before the drawing is approved. A tank that is correct in the catalogue but cannot enter the building is not a solution.

For an export project, add the documentation scope to the review: fire-code basis, material certificates, pressure-test record and O&M instructions. The buyer’s AHJ may ask for documents that are not part of a standard tank quotation. Identify them before award.

Related pages

Read fire protection water tanks for the design inputs, and the welded stainless tank for a seamless-shell alternative. For site checks, use the installation guide.

Send your building constraints and fire basis

Need a product specification for your project?

Send your capacity, flow, water quality, material and site requirements — quotation response within 12 working hours.

Request a Quotation